Roller Water-Absorbing PVA Sponge Mop Oversized Absorbent Sponge Mop Stainless Steel Water Mop Manufacturer

Brand; Sunrich mop+ models; 27 rod material; Stainless steel rod  load-bearing of the mop rod; 10KG following corrosion resistance; 10 wringing method; Roller dehydration rate; 70%(inclusive) -------- 80%(Exclusive)  softening speed of collodion head; 30 miao following mop materials; Collodion Cotton the old model is 38 PVA mop, 30 pieces per piece, 3 colors mixed in 1 box, the new plastic parts are more durable and firmer, and the handle pole has non-slip cover cotton, which is more convenient to use and more labor-saving. Bright color, allowing customers to choose more and sell better new plastic handle, can be hung at will freely retractable latch soft non-slip cover Cotton3-color mixed to pack sunrich tuo ba chang telephone: 13958405818 hu                                    weight: about 05kg retractable: the shortest is 95CM and the longest is 130CM MOP head size: 27cm long operation mode: before using, soak the water for a while to make the glue head soft, then pull the pull ring up until the mop is folded and squeezed dry, the pull ring returns to home position and the bayonet can be used. Front push-back pull mop can be used, which will not cause stagnation when pushing forward like some similar products. When replacing refill, you should wait for the rubber floss head to soak and soften, pull it out from the middle up, align the new rubber floss head with the sockets on both sides, and push the two ends down according to the direction shown in the instructions. When the glue head is dry, it will slightly shrink, but it will return to its original state after soaking, which is purely normal.  Scope of use: it has a wide range of applications, and can clean large areas of floor, floor tiles, marble and other materials. It can also be used for local cleaning. It is suitable for bedrooms, living rooms, kitchens, bathrooms, etc. Note: 1. The glue head will dry and harden after evaporation. Before use, soak it for 5-10 minutes. 2. Cleaning the rubber floss head only needs to be soaked and wrung several times in water repeatedly, and the water temperature should be lower than 40 degrees. 3. To prolong the service life, please avoid direct sunlight as much as possible. 4. The air hole on collodion cotton head will be blocked after long use. Please brush it frequently. Feature introduction: 1. PVA collodion cotton head is 10 times the water absorption of ordinary sponge. It is soft when soaked in water and has strong decontamination ability. It can easily absorb fine dust, hair, sand, glass particles, etc. 2. Push-pull squeeze design, hands do not touch water, easy to squeeze water, collodion cotton head flush can be cleaned, must be free of hands to touch sewage. 3. There is no need to sweep the floor while leaving no trace on the ground. 4. New wisdom lock stainless steel telescopic rod, free length of adjusting rod, to meet the needs of people of different heights. 5. Wide cleaning range, can scrub all kinds of smooth ground, can wipe glass, window, porcelain wall. 6. The fourth generation rubber cotton mop is easy to use, convenient, economical and durable.