Packaging information
CTN Szie: 40 × 30 × 20 cm
G.W./CTN:10 kg
QTY/CTN:150 set/carton
The price of the above pair is 2, and one pair is 2/one set is 2.
The color of this connection is: Rainbow color. White, blue, red, and green.
5 colors, please note the color after shooting!
A pair of 2 lights are equipped with batteries, a pair is equipped with 6 batteries, one is equipped with 3 batteries, the price of a pair is on the Internet, there is no other gift!
[Product description]]
1. It is made of light metal material to effectively protect the valve life. The outer layer is silver plated.3. It can flash at night to increase the safety of driving at night.4. You can add magic color when the vehicle is running, and a little modification can be installed on any part of the vehicle body.5. This Hot Wheels can be used on cars, motorcycles, electric cars and mountain bikes.
[Product name]] tire light[Applicable model]] general-purpose installation site]] vehicle valve on[Type number]] intelligent vibration (you can see the light after installation, it will automatically go out after 15 seconds, and it will start to light again after vibration, which is very energy-saving)
"Material] light Alloy, silver-plated, ultra-light metal base, high-quality high-permeability plastic lamp holder, mechanical assembly line circuit[Power]]6 Section button battery【Specification]3.8cm*1.5cm、 battery service life for 1-3 months
[Advantages]]1. Colorful, very dizzy! Non-monochromatic elimination products on the market.2. Shock! That is to say, only when the car vibrates, it will light up, which greatly saves electricity. Installation method]1. When installing the battery, the positive pole must be downward (the side with words is the positive pole). The battery must be put inside and not exposed, otherwise, the short circuit between the battery and the metal of the lamp shell will cause the battery to run out of power after discharging and heating for a few minutes.2. After the battery is put away, be careful when twisting the lamp holder, make sure that the electrode on the edge of the lamp holder is in good contact with the metal sheet of the lamp shell (if the metal sheet is too close to the outside, you can manually break it inside, but it must be light, don't break it off!), When twisting the lamp holder, the screw buckle must be aligned. The lamp holder must be balanced with the lamp shell. If it cannot be screwed, do not twist it hard. Otherwise, it will easily cause different buttons, and try not to screw it off many times, otherwise it will easily cause the screw buckle to fall off.
Baby effect and show
usage and display:
